debug

Introduction I recently started working on a project where I want to use the RP2040 on a custom board. FYI, the RP2040 is the “chip” used on the Raspberry Pi Pico development board. Development for this board is actually quite straight forward, or at least if you’re on Linux, because that’s what most of the documentation is written for. You simply clone the SDK, install a few prerequisites and start building....

Introduction This is a follow up to my blog post on Bare-metal Rust bootstrapped by C. In this post, I want to discuss how I used the Renode emulator to verify that my setup works. I won’t go into too much detail about how to use Renode. I just want to discuss the part that was relevant for my tests. Installation The first step of getting started with Renode is obviously to install it....